Auvon AS8016 Manual De Instrucciones página 22

Support@iauvon.com
2. The mode and intensity of channel A1 and channel A2
can be different from the mode of channel B1 and channel
B2.
3. When the device is in no output state, it will automatically
shut down if there is no further action within 5 minutes.
HOW TO USE
UK
1. Clean your skin before use. Use the pads on clean and
flat areas, no sweat, no oil.
2. Attach at least one pair pads to the massager area, such
as shoulder and leg.
Note: Adding a few drops of water on the pads and drying
the pads naturally will increase their longevity. Make sure
both pads on the skin and not overlapping.
3. Connect a pair of electrode pads to one lead wire by plug
them on; the other end of the wire is connected to the left
outputs of the device. Similarly, the other pair of electrode
pads is connected to the remaining wire end and the right
outputs of the device.
4. Turn on the device by pressing the " " button of the
unit for 1-2 seconds.
5. Select channel A or channel B by pressing the center
button. If "A" is flashing, which means the channel A1 and
channel A2 are selected. In this case, the intensity and
mode you selected are for channel A1 and channel A2.
6. To increase or decrease the intensity of the corresponding
channel by pressing "+" button or "-" button.
7. Press the "M" button to try different mode. If "A" is
flashing, the selected mode is for channel A1 and channel
A2.
Note: Remember the strength of the corresponding channel
will default to the lowest setting with each mode selection.
8. Recommended application is 10-90 minutes. Increase 10
21