Publicidad
Idiomas disponibles
Idiomas disponibles
Installation components
· Installation of body components.
Using the screw in the package to connect
the handle and the body of the applian-
ce (note the screw hole in the back of the
handle).
· Connection of the electric brush and
body components.
When connecting, place the electric brush
on the floor following the instructions
shown in the illustration, place the brush
mounting hole under the body compo-
nents, insert vertically into the brush con-
nector and press the body components
tightly, finally using the screw of the brush
pack.
EN
Instruction manual
Cordless Vacuum cleaner
Hand vacuum connections and body com-
ponents
When installing the handheld vacuum in
the body assembly, hold the handle of the
handheld vacuum and insert it into the
bottom pointing to the square air inlet of
the body assembly, press the handheld va-
cuum in the direction shown in the figure
until you hear the "lock" sound.
Vacuum installation and charging stand
Align the socket on the back of the va-
cuum cleaner with the support plate in the
base assembly, installing as shown in the
illustration.
Notice: When you stop using the vacuum
cleaner, place the vacuum cleaner on the
stand, do not place it arbitrarily on the
wall or on the edge of the chair to avoid
unnecessary damage due to falls caused
by an unstable place.
Connection of combined accessories and
charging base
Combined accessories can be placed on
the stand when not in use, insert it vertica-
lly according to image 1.
· To remove the handheld vacuum, first
press and hold the handheld release but-
ton and then remove the handheld vacuum
in the direction as shown in the image 2.
REF.: 07694
Publicidad
