Publicidad
Idiomas disponibles
Idiomas disponibles
INPUTS
EN
BRIDGE MODE
Place the selector located on the rear part of the power amplifier in the BRI position.
In this mode, the input of the two channels will be the channel A input signal. The two power amplifier
channels are connected internally so that their power is combined in one single output. Connect the channel
A input and the loudspeaker BRIDGE output. The volume is adjusted with the CH A control.
CH B
GND
LIFT
INPUTS
TECHNICAL SPECIFICATIONS
CHARACTERISTICS Professional stereo power amplifier
STEREO POWER
FUNCTIONS
PROTECTION
CONTROLS
INPUTS
RESPONSE
DISTORTION
DAMPING FACTOR
S/N RATIO
CROSSTALK
SLEW RATE
OUTPUTS
POWER SUPPLY
DIMENSIONS
400 W + 400 W RMS@4
300 W + 300 W RMS@8
STE
BRI
PAR
CH B
(1+, 1-)
-
MODE
STE
BRI
CH A
PAR
SA-606
Stereo and parallel mode:
400 + 400 W RMS at 4 Ω
300 + 300 W RMS at 8 Ω
Bridge mode: 700 W RMS at 8 Ω
Forced ventilation
LED power, protection and signal peak indicators
3 circuits: temperature, short circuit and overload
Volume per channel
GND lift earth disconnection
Parallel/stereo/bridge operating mode selector
CH A and CH B balanced aux line, XLR, 20,000 Ω, 2 V RMS@4 Ω, 2.5 V RMS@8 Ω
and 1 unbalanced aux line, RCA, 10,000, 1 V RMS@4 Ω, 1.23 V RMS@8 Ω
10-50,000 Hz
Harmonic: < 0.05 %
> 150
> 90 dB
> 70 dB
30 V/µs
Loudspeakers: 4-8 Ω stereo, 6.3 mm mono jack, screw terminals and banana
plugs or loudspeaker connector
8 Ω mono bridge, screw terminals and banana plugs
230/115 V AC, 1,000 W maximum
483 x 89 x 350 mm depth
2 U 19" rack
OUTPUTS
CH A
(1+, 1-)
STEREO/
SA-606
PARALLEL
STEREO POWER AMPLIFIER
BRIDGE
8
ONLY
+
+
-
(1+, 2-)
BRIDGE - 8
ONLY
OUTPUTS
600 W RMS@8
- 4 -
~115 V AC, 50/60 Hz FUSE: 16 A
~230 V AC. 50/60 Hz FUSE: 8 A
400 + 400 W RMS, 4
300 + 300 W RMS, 8
600 W RMS BRIDGE 8
AC SELECT
POWER CONSUMPTION: 1,500 W
Publicidad
