Cutting Height; Important - Senix LSPG-M7 Manual Del Operador

Attaching Side Discharge Cover
Your mower is shipped as a mulcher. To convert to side discharge, make sure the
grass catcher is off of the unit and the rear discharge door is closed.
To attach the side discharge cover:
a. Lift the mulching cover.
b. Slide two hooks of side discharge cover under hinge pin on mulching cover
assembly (Figure 8).
c. Lower mulching cover. Do not remove side mulching cover at any time, even
when you are not mulching.
To remove the side discharge cover:
a. Lift the mulching cover.
b. Slide two hooks of side discharge cover out.
c. Let go of the mulching cover.
ADJUSTMENTS

Cutting Height

This product is designed with dual-lever height adjustment (Figure 9).
6 cutting heights (from 1.25inch to 3.75inch) are available.
1. Pull the height adjustment lever outward towards wheel.
2. Move lever to a position of desired cutting height.
3. Release lever towards deck.
IMPORTANT: To avoid unbalance, always keep four wheels at same cutting height.
10
ASSEMBLY
Figure 8
Figure 9
WWW.SENIXTOOLS.COM