STERWINS EHT2-50.31 Manual De Instrucciones página 216

2. SAFETY INSTRUCTIONS
6. Always be sure of a safe and secure operating position, whilst
using the product.
7. the hedge trimmer is intended to be used by the operator at
ground level and not on ladders or any other unstable support.
8. Always ensure the safety guard supplied is fitted before using the
product. Never attempt to use an incomplete product or one fitted
with an unauthorised modification.
9. Check the cutting device regularly for damage, and if damaged
repair immediately.
10.Do not overload the product.
11.Check immediately if the product starts to vibrate abnormally.
Excessive vibration can cause injury.
11.Switch the product off when the cutting device is blocked.
Disconnect it from power supply and remove the blockage.
Inspect the cutting device for damage before using the product
again.
12.Follow the maintenance and repair instructions for this product.
Never carry out any modifications of the product. Information
about maintenance and repair is provided in this instruction
manual.
13.Know how to stop the product quickly in an emergency.
14.Do not expose the product to rain. Do not operate the product on
a wet hedge.
15.Before operating the hedge trimmer, the user should make sure
the locking device(s) of any moving elements (e.g. the extended
shaft and pivotingelement), if any, are in the locked position.
16.Use the product only in daylight or good artificial light.
215
EN