Troubleshooting - STERWINS EHT2-50.31 Manual De Instrucciones

Problems
Product does not
start
Product does not
reach full power
Unsatisfactory
cutting
performance
Excessive
vibration/noise
Installation
Blade cover :
Remove the blade cover 9 from the blade 5 before operation
Align and push the blade cover 9 onto the blade 5 to attach it.
NOTE: Always attach the blade cover 9 when the product is not in use, for storage and
transportation.
To install : To attach, align and slide the battery pack onto the slots of the battery docking
port until it locks in place.
To remove : To release, press the battery unlock button and remove the battery pack from
the product.
EN
Possible cause
Not connected to power supply
Power cord or plug is defective
Other electrical defect to the
product
Extension cord not suitable for
operation with this product
Power source (e.g. generator)
has too low voltage
Air vents are blocked
Blade is worn/damaged
Thickness of branches exceeds
capacity
Blade is damaged
Bolts/nuts are loose
222

5.TROUBLESHOOTING

Solution
Connect to power supply
Have it checked by a specialist electrician
Have it checked by a specialist electrician
Use a proper extension cord
Connect to another power source
Clean the air vents
Have it replaced with new one
Only cut branches complying with the
capacity
Have it replaced with new one
Tighten bolts/nuts