Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTION
-
Connect the loudspeakers to the loudspeaker output required depending on its installation. Do not use
more than one type of output at a time.
-
The loudspeakers must be connected in a series/parallel circuit so that the load impedance of the
loudspeakers is the same as the load impedance of the amplifier output and that the power supplied by
the amplifier does not exceed that withstood by the loudspeakers.
-
Once the connections have been made acording to your needs, connect the devices to the power supply
and switch them on. After use, do not forget to switch off and disconnect the device from the power
supply.
This amplifier has three operating modes that can be selected using the selector located on the rear part of
the device: parallel mode (PARALLEL), stereo mode (STEREO) or bridge mode (BRIDGE).
PARALLEL MODE
Place the selector in the PARALLEL position. In this mode, the outputs A and B will receive the amplified
signal from the CH A input. Connect the CH A input and the two loudspeaker outputs. The volume of the
output channels is adjusted separately.
SA2-1750
POWER AMPLIFIER
450 + 450 W RMS, 8
675 + 675 W RMS, 4
880 + 880 W RMS, 2
1,350 W RMS, BRIDGE 8
1,750 W RMS, BRIDGE 4
STEREO MODE
Place the selector in the STEREO position. In this mode, the two channels operate independently: the CH A
output will receive the CH A input signal and the CH B output from the CH B input. Connect the two inputs
and loudspeaker outputs. The channel volume is adjusted separately.
SA2-1750
POWER AMPLIFIER
450 + 450 W RMS, 8
675 + 675 W RMS, 4
880 + 880 W RMS, 2
1,350 W RMS, BRIDGE 8
1,750 W RMS, BRIDGE 4
PARALLEL
PARALLEL
INPUT
LINK
SENSITIVITY
MODE
0.775 V
BRIDGE
1.0 V
PARALLEL
1.4 V
STEREO
CH A
LINK
30 HZ HI-PASS
ON
GND
OFF
LIFT
CH B
PARALLEL
PARALLEL
R
L
INPUT
LINK
SENSITIVITY
MODE
0.775 V
BRIDGE
1.0 V
PARALLEL
1.4 V
STEREO
CH A
LINK
30 HZ HI-PASS
ON
GND
GND
OFF
LIFT
CH B
MODE
MODE
BRIDGE
BRIDGE
STEREO
STEREO
OUTPUT
(1+, 1-) STEREO
(1+, 2+) BRIDGE
CH A
(1+,1-)
~230 V AC. 50/60 Hz FUSE: 15 A
POWER CONSUMPTION: 990 W
CH B
450 + 450 W RMS a 8
675 + 675 W RMS a 4
880 + 880 W RMS a 2
MODE
MODE
BRIDGE
BRIDGE
STEREO
STEREO
OUTPUT
(1+, 1-) STEREO
(1+, 2+) BRIDGE
CH A
(1+,1-)
~230 V AC. 50/60 Hz FUSE: 15 A
POWER CONSUMPTION: 990 W
CH B
L
450 + 450 W RMS a 8
675 + 675 W RMS a 4
R
880 + 880 W RMS a 2
- 3 -
SA2-1750
SA2-3400
850 + 850 W RMS a 8
1,275 + 1,275 W RMS a 4
1,700 + 1,700 W RMS a 2
SA2-1750
SA2-3400
850 + 850 W RMS a 8
1,275 + 1,275 W RMS a 4
1,700 + 1,700 W RMS a 2
EN
Publicidad
