Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
Disconnect the machine from the power
source before making any repair.
Symptom
Motor will not start
Unit does not reach
high pressure.
Output pressure va-
ries high and low.
All manuals and user guides at all-guides.com
Troubleshooting
Cause
On/Off switch is in the "OFF"
(O) position.
Power cord is not plugged in. Plug in power cord.
Electrical outlet does not sup-
ply adequate power.
Tripped circuit breaker.
Diameter of garden hose is
too small.
Water supply is restricted.
Not enough inlet water supp-
ly.
Water inlet filter is clogged.
Spray wand is on low pressu-
re position.
Not enough inlet water supp-
ly.
Pump is sucking air.
Water inlet filter is clogged.
Discharge nozzle is obstruc-
ted.
Calcified gun, hose or spray
wand.
Solution
Turn switch to the "ON" (I) po-
sition
Try a different outlet.
Switch off pressure washer.
GFCI will reset once the tem-
perature of the unit drops.
Replace with a 5/8 inch or lar-
ger garden hose.
Check garden hose for kinks,
leaks and blockage.
Open water source full force.
Remove filter and rinse out in
warm water.
Turn spray wand to high pres-
sure position.
Turn water on full force.
Check garden hose for kinks,
leaks or blockage.
Check that hoses and fittings
are air tight. Turn off machine
and purge pump by squee-
zing trigger gun until a steady
flow of water emerges throu-
gh the nozzle.
Remove filter and rinse out in
warm water.
Blow out or remove debris
with a fine needle.
Run distilled vinegar through
detergent suction tube.
13
English
Publicidad
