Publicidad
Idiomas disponibles
Idiomas disponibles
Please pay special attention to these hazard alert boxes, and follow any instruc-
tions given. WARNING statements alert you to such dangers as fire, electric
shock, burns and personal injury. CAUTION statements alert you to such dangers
as personal injury and/or property damage.
Before assembling vacuum cleaner, check the PACKING LIST (page 2). Use this list to
verify that you have received and identified all the components of your new Kenmore
vacuum cleaner.
WARNING
Electrical Shock Hazard
DO NOT plug into electrical supply until
assembly is complete. Failure to do so
could result in electrical shock or injury.
POWERMATE
Align wand and insert
onto PowerMate
until
®
the wand locks into
place.
HANDLE ASSEMBLY
Insert wand into
handle until lock
button snaps in
place.
To remove: Press
wand release button
and pull up on
handle.
To store: Disconnect
hose from wand
and canister to
prevent stress on
hose during storage.
Store hose in a
loosely coiled
position so the hose
covering is not
stressed.
ASSEMBLY INSTRUCTIONS
- 8 -
WAND (TELESCOPING)
The wand length is
adjustable and
requires no assembly.
To adjust, simply push
on the wand adjust
button and slide the
upper wand to the
desired height.
NOTE: When adjust-
ing the wand length
you may have to hold
the PowerMate
with
®
your hand or foot.
HOSE
1. Line up the hose
latch tab and
notch in canister
hood and insert
hose into canister
until it snaps into
place.
IMPORTANT:
Push hose connector firmly into the canister
body until the hose latch tab snaps into
place. The vacuum cleaner will not operate
until hose is fully connected.
To remove: Do not open hood before
removing hose. With hood closed, press
hose latch tab and remove hose.
CANISTER
1. Open the canister hood.
2. Check to see that the dust bag is
properly installed. See DUST BAG
CHANGING (page 17) for instructions.
3. Check to see that the motor safety filter
is properly installed. See MOTOR SAFETY
FILTER CLEANING (page 18) for
instructions.
Publicidad
