Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
ASSEMBLING THE BLOWER TUBE
(See Fig. A & Fig. B)
Before assembling the Blower Tube (4), be sure the
on/off switch (2) is in ''O'' Off position.
Fit the Blower Tube to the motor housing as shown
in Fig. A. Fix the blower tube to the blower port with
the screw provided. Check the Blower Tube is firmly
secured.
WARNING! Do not attempt to operate or
disable the On/Off Switch by any means
other than the normal assembly or removal of
the tube.
NOTE: Before disassembling the Blower Tube, be
sure the on/off switch (2) is in ''O'' Off position.
Loosen the screw. Press the Release Button (3), so
that you can separate the tube (See Fig. B). Do not
try to separate the tubes by force or by using tools.
OPERATION
INTENDED USE:
The blower is intended for blow debris.
intended for use indoors and animal grooming.
WARNING! The charger and battery pack
are specially designed to work together
12
so do not attempt to use any other devices.
Never insert or allow metallic objects into
your charger or battery pack connections
because of an electrical failure and hazard will
occur.
1. BEFORE USING YOUR CORDLESS BLOWER
Your battery pack is UNCHARGED and you must
charge once before use.
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not use
another battery charger.
2. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit:
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
Cordless Li-Ion Blower/Sweeper
3. TO REMOVE OR INSTALL BATTERY PACK (See
Fig. C)
Depress the battery release button (6) to release
battery pack from your tool. After recharging, insert
the battery pack into tool's battery port. A simple
push and slight pressure will be sufficient.
4. STARTING/STOPPING (See Fig. D)
Starting
Move the On/Off switch (2) to the "I" On position.
Stopping
Move the On/Off switch (2) to the "O" Off position.
WARNING! The tool runs for a few seconds
after it has been switched off. Let the motor
come to a complete standstill before setting the
tool down.
5. USING THE BLOWER (See Fig. E)
The blower is intended for residential use only.
Use the blower outdoors to move debris from
hard surfaces. This blower is not designed to clear
leaves from large grassy areas, or move wet, heavy
debris.
USER TIPS
It's not
- Hold the blow tube approx 180mm above the
ground when operating the tool.
Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
- After blowing the debris/leaves into a pile, it is
easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as nails,
bolts, or rocks.
- Do not operate the blower near bystanders
or pets.
- Use extra care when cleaning debris from
stairs or other tight areas.
- Wear safety goggles or other suitable eye
protection, long pants, and shoes.
CLEANING THE TOOL
Clean the tool regularly.
WARNING: Keep your product dry. Under no
circumstances spray with water.
- To clean the tool, use only mild soap and a
damp cloth.
EN
Publicidad
