Intended Use - Hilti TE 4-22 Manual De Instrucciones Original

▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 11
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2

Intended use

The product described is a cordless SDS­Plus rotary hammer drill. It is designed for hammer drilling in
concrete and masonry, for drilling in steel, wood and masonry and for driving and removing screws.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Items supplied
SDS­Plus rotary hammer drill, side handle, grease, depth gauge, operating instructions.
The TE DRS-4⁄6 (01) dust removal module greatly reduces dust emissions and is available as an accessory.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 ATC
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the product will suddenly pivot about its own axis in the opposite direction.
ATC detects this sudden pivoting movement of the product and switches the product off immediately.
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
6 English
1
Dust cap
@
Chuck (blade holder)
;
Connection for the dust collection module
=
Function selector switch
%
Depth gauge
&
Forward/reverse switch with transport lock
(
Control switch
)
Grip
+
Installation opening for accessories
§
Battery
/
Battery release button
:
Battery status indicator
∙
Connection for the TE DRS­4⁄6 (01) dust re-
$
moval module
Side handle
£
LED lighting
|
2265063
*2265063*