Shark AI ULTRA ROBOT RV2600WDEU Manual De Instrucciones página 27

CHARGE INDICATOR LIGHTS
NOTE: If the low charge light is blinking red, there is not enough battery power for the robot to return to the dock.
Manually place the robot on the dock.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
section of the floor to ensure there is no scratching.
sha rkcl e a n.eu
In Use
Full Partial Low
Charge Charge Charge
(White) (White) (Red)
While
Charging
(White)
No Charge
or Off
The white charge indicator lights show how much
battery power is remaining.
While the robot is charging, both white LED lights
will flash. When charging is complete, both white
lights will illuminate steadily. It may take up to 6
hours to fully charge your robot.
If the robot is idle and away from the charging
dock for 10 minutes, it will enter Sleep Mode. The
indicator lights will turn off, but the battery and
Wi-Fi lights will remain on in sleep mode. Wake up
the robot by pressing any button.
BUTTONS AND INDICATOR LIGHTS
RECHARGE & RESUME
Press and hold the DOCK
button for 15 seconds to turn
Recharge & Resume ON or
OFF.
The Recharge & Resume function is turned OFF by
default. Turn ON Recharge & Resume for complete
coverage if your home's floor plan is bigger than
140m2. Your robot will return to the dock, recharge,
and can pick up where it left off.
CLEAN BUTTON
Press to begin a cleaning
session and press again to
pause the cleaning session.
DOCK BUTTON
Hold down for 5 to 7 seconds
to power on the robot. Press
to stop cleaning and send
robot back to the charging
dock.
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
WET MOPPING
INDICATOR LIGHT
The CLEAN button will
illuminate blue when the fluid
reservoir is properly installed.
The CLEAN button will
illuminate yellow if the tank is
empty and needs refilling.
"!" ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
WI-FI INDICATOR
White light: connected to
Wi-Fi.
Red light: not connected.
Flashing White: setup mode.
No light: not set up yet.
s ha rkc lea n.eu