Publicidad
Idiomas disponibles
Idiomas disponibles
7. STARTING AND USING INSTRUCTIONS.
WARNING: Before starting the machine, read the instructions
carefully and observe safety rules recommended in this manual and
labor safety standards of each location to avoid accidents, damage and
injury.
7.1 WATER TANK
The joint cutter TRENCHER 60-70 incorporates two water tanks. A 40
liters rear water tank (A, Fig.3) and a 20 liters front water tank (B, Fig.3) for
cooling the blades. The two tanks are connected to each other as if it were a
single tank, feeding the two blades at once. The maximum range is 60 liters in
total and takes approximately 15 minutes to run out of water.
Each tank has a water valve (A, Fig.4) to cut the flow of water.
If you want to cut only with a blade, you must shut off the water valve
located opposite (A, Fig.5) to the cutting blade.
7.2 FITTING THE BLADE
You will get better performance and results if you always use the
appropriate diamond blade for each material to be cut. The Diamond
blades used are water cooled for which the floor saw includes a cooling
system that guarantees the appropriate flow of water needed to cool the
blade.
Depending on the machine model proceed to
remove the blade guard in one of the following methods.
If your machine model has this kind of nuts (P. Fig.6),
you have to remove them and then remove the blade
guard (T, Fig. 6).
If your machine model does not assemble the kind of
nuts mentioned before, the blade guards are foldable. Proceed
with the following method:
• Disconnect the water hose from the guard (E, Fig. 7).
• Loosen the nuts (A, Fig. 7) that hold the guard with the
chassis with the 17 mm flat wrench included with the machine.
It is not need to remove the nuts completely.
• Fold the maximum guards on the screw that serves as the
rotation axis (B, Fig. 7).
11
ENGLISH
Publicidad
