Battery Charger Configuration - Lavorwash QUICK 36E Manual

5.3.

BATTERY CHARGER CONFIGURATION

• We recommend to call the assistance centre or a
technician if you have problems with the setting given.
The machine is equipped with a battery charger con-
figurated for OPTIMA maintenance free battery.
If the operator whish to use Pb-Acid battery or GEL/
AGM battery, it is necessary to change the battery
charger settings as follows:
• DISPLAY OF THE BATTERY CHARGER SETTINGS
The battery charger settings are shown by the blink-
ing of the LED indicator when the battery charger is
switching on:
- the RED LED indicator ( Photo 17 - B ) flashes 2
times = the battery charger is set for PB-Acid batteries
- the GREEN LED indicator ( Photo 17 - C ) flashes
2 times = the battery charger is set for GEL/AGM or
OPTIMA batteries
B
A
Photo 17
Table A
Tipo di
batteria
Pb-Acido
Gel / AGM
Optima
5. INSTALLATION INFORMATIONS
E
SW1
Dip-Switch 1 Dip-Switch 2
OFF ON
OFF OFF
OFF ON
The battery charger settings will be displayed even if
the battery is not connected.
• DIP-SWITCH CONFIGURATION FOR CHARGING CURVE
SETTINGS FOR BATTERY CHARGER CBHD1 12V 6A
To set the charging curve type for Pb-Acid, GEL/AGM
or OPTIMA batteries it is necessary to operate on the
dip-switches placed inside the battery charger (
Photo 17 - D ) ( Photo 17 - F ).
To access the dip-switches it is necessary to remove
the lower panel of the battery charger ( Photo 17 - A );
it is also possible to reach the dip-switches by remov-
ing the plastic cap ( Photo 17 - E ).
Refer to the relevant manufacturer's manual provided.
To configurate the charging curve related to the
different battery type it is necessary to set the dip-
switches as indicated in the Table A here below:
A) Battery charger cover
B) Red "LED" - Battery discharged
C
C) Green "LED" - Battery charged
D) Dip-Switches
E) Plastic cap
F) Dip-Switches for charging curve setting
SW1 SW2
F
SW2
Dip-Switch 1 Dip-Switch 2
ON
OFF
OFF
38
SW 1 SW 2
ON ON ON
OFF OFF OFF
DIP 1 DIP 2 DIP 1
ON
ON
OFF
ON
OFF
OFF
DIP 2