Care And Maintenance - Collomix AQiX Manual De Servicio Original

Care and maintenance

Clean equipment:
Changing the ba琀琀eries:
Replacing the hose
connec琀椀on:
Cleaning the screen:
Back-昀氀ushing:
Faults - Troubleshoo琀椀ng
No琀椀昀椀ca琀椀on in the display
Keep the device clean and remove any dirt immediately.
Clean the device with a damp cloth and a mild cleaning detergent (soap). Do not use any
cleaning agents containing solvents.
To change the ba琀琀eries, open the ba琀琀ery compartment (3) cover using a screwdriver.
Remove the old ba琀琀eries.
Insert the new ba琀琀eries (AA) in the ba琀琀ery compartment according to the labelling.
Remove the rubber seal from the cover and clean it. Do not damage the seal. We recom-
mend lubrica琀椀ng the seal with silicone grease.
Reinsert the rubber seal into the groove of the cover, ensuring the seal 昀椀ts exactly.
Before screwing the cover back on, make sure that the rubber seal is not crushed. You can
tell that a seal is not properly seated as the gap in the cover is not parallel.
Place the cover so that it is level and screw it back into place with the 3 screws.
If the seals are not inserted correctly, this may impair the leak-琀椀ghtness of the device. Do
not reuse damaged seals.
Loosen by turning counter-clockwise
Place the new hose coupling with seal on the thread and 琀椀ghten in the clockwise direc琀椀on.
There is a par琀椀culate screen in the water supply (5) that holds back larger par琀椀cles in the
supply water. It is recommended to clean the screen from 琀椀me to 琀椀me.
Unscrew the hose connec琀椀on as described above.
Use pliers to grab the screen at the protruding screen clip and pull it out.
Clean the screen under 昀氀owing water and re-insert it.
Screw the hose connec琀椀on back on.
There is also a screen before the water outlet (7). If the amount of water decreases signif-
icantly, this needs to be cleaned.
The hose must be connected to the water outlet only for this reason and this reason only.
At the same 琀椀me, the second screen at the water supply (5) must be removed (see above).
Then 昀氀ush the device backwards to remove the deposits.
Then disconnect the hose and re-insert the screen at the water supply.
Descrip琀椀on
BAT no琀椀昀椀ca琀椀on in the display area
visualizes that the ba琀琀ery is empty
Display of a circumferen琀椀al line
visualizes that there is no water in
the device
No no琀椀昀椀ca琀椀on in display a昀琀er
pressing the "START/PAUSE" bu琀琀on
Rec琀椀昀椀ca琀椀on
Change the ba琀琀eries
• Ensure a water supply to the device
• Check whether the device inlet is dirty and
remove any dirt if necessary
• Change the ba琀琀eries
• If there is s琀椀ll no no琀椀昀椀ca琀椀on a昀琀er changing
the ba琀琀eries, then send in the device for repair