Descargar Imprimir esta página

Switching On / Off; Care And Maintenance - Hilti NURON TE 30-22 Manual De Instrucciones

Ocultar thumbs Ver también para NURON TE 30-22:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 61
5.10
Removing accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Pull the chuck ring back as far as it will go and remove the accessory tool.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1

Switching on / off

1. To switch the product on, operate the control switch.
Speed can be controlled steplessly by varying how far the control switch is pressed in.
2. To switch the product off, release the control switch.
6.2
Forward / reverse
▶ Set the forward / reverse switch to the desired direction of rotation.
6.3
Function selector switch
▶ Set the function selector switch to the desired working position.
▶ Do not operate the function selector switch while the motor is running. Risk of damage!
6.3.1
Drilling without hammering
▶ Set the function selector switch to this symbol:
6.3.2
Drilling with hammering action (hammer drilling)
▶ Set the function selector switch to this symbol:
6.3.3
Chisel positioning
▶ Set the function selector switch to this symbol:
▶ The chisel can be adjusted to 12 different positions (in 30° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
6.3.4
Chiseling
▶ Set the function selector switch to this symbol:
6.4
Screwdriving
1. Change the chuck.
2. Set the forward/reverse switch to the desired direction of rotation.
7

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
Carefully remove stubborn dirt.
Carefully clean the air vents, if present, with a dry, soft brush.
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Use a dry, clean cloth to clean the contacts of the product.
24
English
9
10
11
.
.
.
.
2264906
*2264906*

Publicidad

loading