Descargar Imprimir esta página

Preparations At The Workplace; Charging The Battery; Inserting The Battery - Hilti NURON NCT 45 S-22 Manual De Instrucciones

Ocultar thumbs Ver también para NURON NCT 45 S-22:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 55
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 18
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3
Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4
Switching starting lock on/off
The cutting tool has a starting lock that can be optionally activated or deactivated. If the starting lock is
activated, the control switch has to be pressed twice to start the cutting operation. This prevents inadvertent
starting.
The factory default is starting lock deactivated.
1. Remove the battery. → page 21
2. Press and hold down the control switch.
3. Insert the battery into the cutting tool.
4. Release the control switch.
▶ The green LED flashes twice; acoustic signal sounds twice: starting lock activated
▶ The green LED flashes twice; acoustic signal sounds once: starting lock deactivated
5.5
Changing the cutting edges
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before inserting, changing or removing the cutting edges.
1. Turn the cutting head so that the locking lever and pivoting bar are easily accessible.
2. Open the locking lever.
3. Flip the pivoting bar open.
4. Undo the securing screw of the cutting edge in the pivoting bar.
5. Pull the cutting edge out of the pivoting bar.
*2321709*
2
2321709
English
21

Publicidad

loading