70
Troubleshooting
You can carry out a number of checks yourself before sending a product for
repair.
Troubleshooting guide
Problem
Nothing happens when the
transmitter is activated with the
Test Button (1).
The Visit Receivers occasionally
indicate a fire alarm for no ap-
parent reason.
The Smoke Alarm can be acti-
vated with the test button (1) but
the receivers are not responding.
The LED (1) blinks yellow or in a
strange manner.
The receiver signals when no
transmitter is activated.
The Smoke Alarm beeps and
chirps in a different way from that
indicated above for no reason.
Solution
Change the battery. Use a Duracell
MN1604, Energizer 522 (alkaline) or
Ultralife U9VL-J-P (lithium).
Change the battery. Use a Duracell
MN1604, Energizer 522 (alkaline) or
Ultralife U9VL-J-P (lithium).
Change the Radio Key on all units in
the system. For further information see
Function/Radio Key.
Check that the Smoke Alarm's antenna
is straight and points to the floor.
Check that the receivers are not placed
too far away by moving them closer to
the Smoke Alarm.
Check the battery in the receiver.
Check that all units in the Visit System
are set to the same Radio Key. For fur-
ther information see Appendix/Further
information/Settings/Radio Key.
Refer to the Guard Receiver User Manual
if the Smoke Alarm is connected to a sys-
tem with a BE1465 Visit Guard Receiver.
If the Smoke Alarm is not connected
to a system with a BE1465 Visit Guard
Receiver, check that the Guard Receiver
Switch (8) is in position 0.
Change the Radio Key on all units in the
relevant Visit System. There is probably
another system nearby with the same
Radio Key.
The Smoke Alarm is defective and
needs to be sent for repair.