Faults, Alarms And Breakdowns; Recycling The Product - Fagor C-G920 Instrucciones De Instalación, Uso Y Mantenimiento

6. FAULTS, ALARMS AND BREAKDOWNS

The steps to be followed in the event of a fault or operating error are described below. The possible causes and
possible solutions are listed in the following table. In the event of doubt, or if you are unable to resolve the problem,
please contact the technical service.
Do not handle electrical components, as there is a risk of death as the components are live.
Problem
Smell of gas
Flame is yellow.
Oven ignition pilot does
not light.
Open flame or hotplate
burner ignition pilot light
does not light.
Oven, open flame or
hotplate burner ignition
pilot light does not go out.
The oven does not heat up
Open top burners do not
light.
It is not possible to adjust
the temperature of the
oven.
NOTE: If a fault occurs and is not listed in the above table, please call the technical service.
The manufacturer reserves the right to modify the technical characteristics with prior
warning.

7. RECYCLING THE PRODUCT

The European standard 2012/19/EU on the disposal of electrical and electronic appliances, must
not be disposed of in the same way as solid urban waste. Old appliances must be disposed of
separately to optimise the percentage of materials recovered and recycled and to prevent
potential damage to health and to the environment. The crossed-out bin symbol is displayed on
all the products to remind users of their obligation to dispose of the product separately. For further
information on the correct disposal of electrical kitchen appliances, users may refer to the
relevant public authority or other retailers.
Cause
Occasional gas leak caused by flame
going out.
Dirty burner
Piezoelectric igniter does not work.
The pilot light is blocked.
Air in pipes due to long period of
inactivity.
The pilot light is blocked.
Air in pipes due to long period of
inactivity.
Thermocouple not heated enough.
Broken valve
Insufficient gas pressure.
Inter-ignition groove of burner blocked.
Insufficient gas pressure.
Broken valve
Solution
Close the gas supply and ventilate the
premises.
Contact your Technical Assistance
Service.
Manually switch on the oven.
your Technical Assistance Service.
Clean the pilot light.
Repeat ignition process.
Clean the pilot light.
Repeat ignition process.
Repeat ignition process.
Contact your Technical Assistance
Service.
Contact your Technical Assistance
Service.
Clean inter-ignition groove of burner
body.
Contact your Technical Assistance
Service.
Contact your Technical Assistance
Service.
Contact
51