Installing The Device - Dometic SMP 439 Instrucciones De Montaje Y De Uso

SMP439, 439-08
No. in
fig. 1, page 3
7
8
No. in
fig. 2, page 4
1
2
3
4
5
6
7
8
6

Installing the device

6.1 Fastening the device
When selecting the installation location, observe the following instructions:
• The device should be installed vertically.
• Do not install the device
– In wet or damp environments
– In dusty environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
• The place of installation must be well ventilated. A ventilation system must be
available for installations in small, enclosed spaces. The clearance around the
device must be at least 25 cm.
• The air inlet on both short sides of the device must remain clear.
• For ambient temperatures higher than 40 °C (such as in engine or heating com-
partments, or direct sunlight), the heat from the device under load can lead to
reduced output.
EN
Explanation/function: SMP439
Battery type selector button
Battery connector
Explanation/function: SMP439-08
Input for AC power supply
Battery connector A2, 10A
Status LED A2
LIN1 connection socket
SMP-ON
Status LED A1
Battery type selector button
Battery connector A1, 15A
Installing the device
13