Driving Screws - EGAmaster 66508 Manual De Instrucciones

forward motion. The direction is reversed when the selector
is fully down.
Setting the direction of rotation selector in the center (locked)
position helps reduce the possibility of accidental starting
when not in use.
NOTE: The screwdriver will not run unless the direction of
rotation selector is pushed fully up or down.
NOTICE:
To prevent gear damage, always allow the collet to
come to a complete stop before changing the direction
of rotation.
To stop the screwdriver, release the switch trigger and allow
the collet to come to a complete stop.
TO LOAD/RELEASE BITS
See Figure 5,
Insert the bit into the collet and push the bit in as far as possible.
To remove a bit, pull the bit straight out of the collet.
TURN ON/OFF THE LIGHT
See Figure 6,
To turn on the light, press the LED light.
To turn off the light, press the LED light agian.

DRIVING SCREWS

See Figure 7, 8,
Check the direction of rotation selector for the correct
setting (forward or reverse)
Hold the tool firmly and place the bit at the point where
the screw is to be driven.
Hold and turn the torque ring and select the proper torque.
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire will
make exposed metal parts of the tool "live" and possibly
shock the operator. If you must drive a screw where hidden
wire may be present, always hold tool by insulated
gripping surfaces (handle) when performing the operation
to prevent a shock to the operator.
Depress the switch trigger to start the tool.
Apply only enough pressure to keep driving the screw.
Do not force the tool. Let the tool do the work.
30