Submerged Installation Of The Pump; Commissioning/Start-Up; Switching On/Off - Oase Aquarius Eco Expert 22000 Puesta En Marcha

NOTE
The unit will be damaged, if water enters the plug connector.
• Connect the plug connector or place the protective cap on the plug connector.
– Ensure that the rubber seal is clean and fits exactly. If the rubber seal is damaged, it must
be replaced.
– Secure the plug connector or the protective cap with the two screws.

Submerged installation of the pump

Connecting
 B
Do not plug the power plug into the socket yet!
Installation
 C
• Place the pump horizontally on a stable, mud-free surface.
• Ensure secure and stable positioning of the pump.
• Only operate the pump when it is fully submerged.

The pull rope allows you to simply pull the pump from the water.
− Fasten the pull rope on the bottom filter casing through the round openings and make a
knot.

Commissioning/start-up

NOTE
Never connect the pump to a dimmer. Otherwise the pump will be destroyed.
NOTE
Prevent the pump from running dry. Otherwise the pump will be destroyed.
 Only operate the pump when it is submerged or flooded.

Switching ON/OFF

• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
• Switching off: Pull the power plug from the outlet.
EN
15