1. Introduction
The BETEX iDuctor 1 and iDuctor 2 uses the phenomenon of induction to heat magnetisable
metal components such as nuts. Whether a particular material can be heated can be
determined by experimentation. A set of eight different induction spirals, one U-coil and a
flexible induction coil are available to allow heating of a wide range of components: small
drive components, bearings, rings, housings, pipes, nuts, bolts, small surfaces.
Read this user manual first before you use the BETEX iDuctor!
1�1 Items supplied
The BETEX iDuctor is supplied as a complete set in a robust box with the following contents:
• iDuctor
• 1 flexible inductor, 2 mtr
• heat resistant gloves (150°C)
• a mains cable with IEC Lock
• user manual
• safety data sheet
1�2 Optional inductors
• set of 9 inductors: 8 spirals, 1 U-coil
• flexible inductor: 1,1 mtr
• ID-pad flat surface inductor
• heat resistant gloves 300°C
© BETEX Tools
EN
DE
ES
FR
NL
IT
5