Publicidad
Step 7
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown
in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (40MA) to the LEFT END (B) and LEFT UPRIGHT (R). Use
four GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other hole
that lines up with the hole in the END and UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWER.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
Groove
B
Open end
Page 12
4
3
2
1
427030
40MA
R
3
4
7
Open end
1
2
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
www.sauder.com/service
Publicidad
