Publicidad
Idiomas disponibles
Idiomas disponibles
10.Side support bar
11.Table fence
12.Bevel angle scale.
13.Bevel angle scale pointer.
14.Dust bag
15.On/Off Switch
16.Dust bag connector.
17.Locking bolt
18.Bevel lever handle
19.Rear support
20.Working clamp
21. Upper handle
22. Allen key
23. Saw sha
24. Upper guard
25. Cover plate
26. Flange bolt
27. Slide lock knob
28. Flange
1.Rear support ( Fig 1,2 )
The rear support (19) are under the base (6).
Deploy the rear support and (19) engage them correctly into the clips (19a) provided at the bo om plate of
the machine.
2.W
Low
-When the locking bolt (17) is unlock
toma
to the ma
t
-A er each job lock the machine in the tr
efore store the machine.
Press the handle (1) slo
reach the lowes
ress the locking bolt (17) and slowly guide the
handle (1) in upwards dir
by the locking bolt (17)
3.Support bar. (Fig 6+7)
-Insert the end of the support (10) into the holes at the base (6)
Tighten the locking bolts (10a)
4.Install work piece clamp (Fig. 8)
The work piece clamp (20) can be mounted at both side of the base.
Note : If the mitre or bevel angle is adjusted and the motor housing will swing to the le
you can
mount the work piece clamp at the right side.
-Loosen the locking bolts (20a) located at the support bar (20b)
-Insert the work piece clamp (20f) at the holes of the support bar (20b)
-If the w
correctly
hten the locking bolts (20a)
5.Dust c
Squeeze the metal clamp (19a) at the dust c
ove it over the dust c
6.Install of a sta
ry machine (Fig. 10)
This machine is used as a sta
ry machine only, Never use this machine as a mobile tool.
7
GB
Publicidad
