Descargar Imprimir esta página

Snap-On CTBTS9050 Traducción De Las Instrucciones Originales página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Battery Charger Troubleshooting
PROBLEM








changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator and your
body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
ZCTBTS9050
POSSIBLE CAUSES
Undervoltage
Tool overtemperature
Overcurrent
Motor wire break
Controller fault
Controller overtemperature
Hardware fault
Hall effect error
CTL failure
10
REASON/SOLUTION
Replace battery with a fully
charged battery.
Let tool sit 5-10 minutes then
resume work
Let tool sit 5-10 minutes then
resume work
Return to dealer for repair
Return to dealer for repair
Let tool sit 5-10 minutes then
resume work
Return to dealer for repair
Return to dealer for repair
Replace battery with a fully
charged battery.
(04/19)

Publicidad

loading