Publicidad
Step 17
å
Flip the drawer over onto the LEFT DRAWER SIDE (D32).
å
Diagram 1. Insert the tabs on a DRAWER STOP (20G) into the slots in an EXTENSION SLIDE (40MC). You may need to
insert one tab first, then the other.
å
Diagram 2. Visually check that the DRAWER STOP (20G) is seated in the SLIDE (40MC).
å
Diagram 3. If the DRAWER STOP is not seated, use your hammer to gently tap the SLIDE until the tabs are properly seated
in the slots.
å
Now, fasten the EXTENSION SLIDE (40MC) to the RIGHT DRAWER SIDE (D33). Use two GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #2 and #4.
1.
40MC
These tabs must insert into the slots.
2.
20G
3.
Page 22
Slot
GOLD 5/16" FLAT HEAD SCREW
20G
Post
20G
40MC
Seated
3S
(4 used for the SLIDES)
427565
1
2
3
4
D33
D32
www.sauder.com/service
7
Open end
Publicidad
