DeWalt DC305 Manual Del Usuario página 33

All manuals and user guides at all-guides.com
to AC, the red charging indicators (8) may
fl ash together with two fast blinks followed
by a pause. This indicates a temporary
problem of the power source. The charger will
automatically switch back to normal operation.
Charging process (fi g. B)
Refer the table below for the state of charge of the
battery pack.
State of charge
1 light blinkling
1 light blinkling, 1 light on
1 light blinkling, 2 lights on
3 lights on
Automatic refresh
● The automatic refresh mode will equalize or
balance the individual cells in the battery pack
at its peak capacity. Battery packs should be
refreshed weekly or whenever the pack no
longer delivers the same amount of work.
● To refresh your battery pack, place the battery
in the charger as usual. Leave the battery pack
for at least 8 hours in the charger.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot
or too cold, it automatically starts a Hot/Cold Pack
Delay, suspending charging until the battery has
reached an appropriate temperature. The charger
then automatically switches to the pack charging
mode. This feature ensures maximum battery life.
Deep discharge protection
The battery pack is protected against deep
discharging when it is used in the tool.
Replacing the saw blade (fi g. C)
● Move the blade clamp lever (10) up to release
the blade clamping mechanism.
● Insert the saw blade into the holder (11) until it
engages. The blade can be installed with the
teeth pointing down or up, or left or right.
● Move the blade clamp lever (10) down to lock
the blade clamping mechanism.
● To remove the saw blade, proceed in reverse
order.
Saw blades
Material
ferrous metal
non ferrous metal
wood
plastic
masonry
A wide variety of dedicated saw blades is available
as an option.
< 33%
WARNING: Always select your saw
33-66%
blade with great care.
66-99%
100%
Setting the adjustable saw shoe (fi g. D)
The saw shoe can be adjusted to limit the depth of
cut and prolong the life of your saw blade.
● Push and hold the release button (12).
● Slide the saw shoe (4) into one of the 3 settings.
● Release the button.
Instructions for use
WARNING:
● Always observe the safety instructions
and applicable regulations.
● Ensure the material to be sawn is
secured in place.
● Apply only a gentle pressure to the tool
and do not exert side pressure on the
saw blade. If possible, work with the saw
shoe pressed against the workpiece.
This prevents damage to the blade and
stops the tool from jerking and vibrating.
● When sawing in walls or fl oors be aware
of the location of pipework and wiring.
Always hold the tool by its handle.
● Avoid overloading.
● Let the blade run freely for a few
seconds before starting the cut. Never
switch on the tool when the saw blade
is jammed in the workpiece or in
contact with the material.
Prior to operation:
● Make sure your battery pack is (fully) charged.
● Make sure the battery pack is properly seated.
E N G L I S H
Recommended saw blade
fi ne-toothed
coarse-toothed
coarse-toothed
fi ne-toothed
carbide-tipped
31