Installation Instructions - Danby Designer DDEF03813BD13 Manual Del Propietário

INSTALLATION INSTRUCTIONS

PREPARATION
WARNING: This product includes glass. Always use extreme caution
when handling glass. Failure to do so could result in personal injury or
property damage.
Remove all parts and hardware from the carton and place them on a
clean, soft, dry surface.
WARNING: Make sure all parts are dry and the power cord and plug
are not damaged. See the Important Instructions section.
The fi replace can be wall-mounted or placed on a solid, level surface
when the free standing feet are assembled. The fi replace must be
plugged into a 120V 60Hz electrical outlet.
FREE STANDING FOOT ASSEMBLY
Carefully lay the fi replace on a fl oor or table. Place the fi replace on a
blanket or soft surface to avoid scratching it or causing damage to your
furniture or fl ooring.
Attach the free standing feet using eight 4 x 16 mm screws as shown.
Place upright on a solid, level surface and plug into a 120V 60Hz
electrical outlet.
Note: If you attach the solid feet for freestanding installation, you do not
need to install the wall bracket onto the back of the fi replace.
9