Operation; Put Heating Into Operation; Troubleshooting; Maintenance - welltherm BP550 Serie Instrucciones De Instalación Y Funcionamiento

5 - Operation

5.1 - Put heating into
operation
Condition:
Initial commissioning

5.2 - Troubleshooting

Recognize malfunctions
and remedy

5.3 - Maintenance

5.4 - T ake heating out of
operation
30
Switch on the power supply to the heater.
If a pleasant warmth does not appear immediately, then leave the heater
in operation for a longer period of time until a pleasant room climate is
created.
- As soon as all solid bodies are warmed up, a pleasant warmth is created
in the room.
Put all the radio control components you are using into operation. Read
the respective operating instructions for this.
If the heater does not emit any heat, check whether the heater in the area
of heating zone 1 is covered or dirty.
It is possible that the safety temperature limiters integrated in
the heater have switched off the heater. In this case, wait for
the cooling phase. The heating switches on again automatically.
The surface color of the heater may change due to room air contaminati-
on, e.g. cigarette smoke, fireplace/stove or cooking vapors.
After the cooling phase, clean the heater at regular intervals with a damp
cloth and some solvent-free soap.
Caution! Risk of material damage due to unsuitable cleaning agents!
Switch off the power supply to the heater.