Cleaning The Strainer - Bestway 58500E Manuel De Instrucciones

CLEANING THE STRAINER

1. Switch off the sand filter and set the
Control Valve to the Closed function.
2. Close the connection valves.
3. Remove the Strainer Cover by unscrewing
it.
4. Take out the Strainer, remove any debris.
5. Put the Strainer back into position. Ensure
the hole in the strainer is aligned.
6. Ensure the Seal Ring is in place. Secure
the Strainer Cover back.
7. Open the connection valves.
NOTE:
dirty or blocked strainer will reduce the performance of the sand filter.
LOWERING OR DRAINING POOL WATER
1. Switch off the sand filter and set Control Valve to the Drain
function.
2. Detach the Hose from the connection valve's Port A and
sand filter Port A and attach to Port D.
3. Switch on the sand filter to remove pool water.
WARNING
STORAGE
In areas that have freezing winter temperatures, pool
equipment must be winterized to protect against damage.
Allowing water to freeze will damage the sand filter and void
warranty.
1. Backwash the sand filter.
2. Drain the pool according to the pool owner's manual.
3. Unscrew the drain valve cap at the bottom of the tank and
release the remaining water.
4. Disconnect the two Hoses from the pool and the sand filter.
5. Completely spill the sand out of the tank and dry all
components.
6. Move away sand filter from pool area, store the sand filter
in a dry indoor location out of child's reach.
The Strainer must be emptied and cleaned periodically. A
:
DO NOT DRY RUN THE SAND FILTER.
15