Setting A Timed Event To Occur Once Only; Setting A Timed Event To Occur In The "Security" Mode; Reviewing Timer Events - Marmitek MT20 Mini Timer Modo De Empleo

Idiomas disponibles

If you try to set an on or off time and the memory is full, the display will read FULL. To

clear this, press the Clear button.

Setting a timed event to occur Once only

If (within 4 seconds after setting an On or Off time) you press the "Mode" button

once or twice until Once shows in the display, you will modify the program for that

particular Unit Code to occur only Once.

The event you have programmed will happen (at the time you have programmed)

within the next 24 hours, and will then be automatically cleared from memory and

will not happen again the next day.

You can mix Once and Daily events for the same Unit Code (up to the 64 maximum

events for all 8 unit codes).

If you advance to a specific time, and then press one of the ON or OFF buttons, you

will set an On or Off time for that Unit Code to occur every day at exactly the same

time.

If however, within 4 seconds after setting an On or Off time, you press the "Mode"

button once or twice until Security is shown in the display, you will modify the

program for that particular Unit Code to occur every day at a slightly different time

each day.

The event you have programmed will happen at the time you have programmed on

the first day, and will then happen at a different time on each subsequent day (within

the hour you have programmed). For example:

If you advance to 7:35 PM, press the ON button for number 2 and then (within 4

seconds) press the Mode button once or twice until Security shows in the display, the

Module(s) set to Unit Code number 2 will go On at exactly 7:35 PM on the first day

and any time between 7:00 PM and 8:00 PM every day after that. This time will vary

each day so that the Module doesn't go on at the same time each day (to give your

home a lived-in look).

You can mix Once, Daily, and Security events for the same Unit Code (up to the 64

maximum events for all 8 unit codes). See note at bottom of Setting something to

happen every day at the same time

buttons is pressed without modifying the current time, and no events are in

memory for that module, 0:00 is displayed.

Set the Mode Switch in the "Prog Set/Review" position. If no

events exist in memory 0:00 is displayed, otherwise the first event

found in memory is displayed.

If (while in Prog/Review Mode) one of the 4 module ON (or OFF)

Tabla de Contenido