Safety Instructions For Maintenance; Assembly; Operation - Husqvarna 129C Manual De Usuario

sure that the storage area does not contain an open
flame.
• Only use approved containers when you move the
fuel or put the fuel into storage.
• Empty the fuel tank before long-term storage. Obey
the local law on where to dispose fuel.
• Clean the product before long-term storage.
• Remove the spark plug cable before you put the
product into storage to make sure that the engine
does not start accidentally.
WARNING:
before you assemble the product.
To attach the loop handle
1. Attach the loop handle to the shaft in compliance
with the illustration and tighten. (Fig. 23)
2. Make sure that the loop handle attaches between
the arrows on the shaft.
To assemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling. (Fig. 24)
2. Align the tab of the shaft (A) with the arrow on the
shaft coupling (B). (Fig. 25)
3. Push the shaft into the shaft coupling until the shaft
attaches. (Fig. 26)
4. Make sure that you tighten the knob before you use
the product. (Fig. 27)
To disassemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling. (Fig. 28)
2. Push and hold the button (C). (Fig. 29) Hold the
engine end and pull the shaft out of the shaft
coupling.
WARNING:
safety chapter before you operate the
product.
Fuel
To use fuel
CAUTION:
cycle engine. Use a mixture of gasoline
and two-cycle engine oil. Make sure to use
the correct quantity of oil in the mixture.
Incorrect ratio of gasoline and oil can cause
damage to the engine.
155 - 010 -

Assembly

Read the safety chapter

Operation

Read and understand the
This product has a two-

Safety instructions for maintenance

• If you cannot adjust the idle speed to make the
cutting attachment stop, speak to your service
center. Do not use the product until the product is
correctly adjusted or repaired.
To assemble the cutting attachment
To attach the cutting attachment guard and
the trimmer head (straight shaft)
1. Attach the cutting attachment guard (A) to the shaft
with the bolt (L).
2. Attach the drive disc (B) to the output shaft.
3. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
4. Put a small screwdriver (C) in the hole to lock the
shaft. (Fig. 30)
5. Turn the trimmer head (H) counterclockwise to
tighten the trimmer head to the gearbox. (Left hand
threads.) (Fig. 31)
To attach the cutting attachment guard and
trimmer head (curved shaft)
1. Attach the guard. (Fig. 32) Tighten the nut.
2. Attach the dust cup on the shaft. (Fig. 33)
3. Hold the dust cup with an adjustable wrench to make
sure the shaft does not turn.
4. Attach the trimmer head to the shaft. Turn the
trimmer head clockwise.
Gasoline
CAUTION:
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
CAUTION:
more than 10% ethanol concentration (E10).
This can cause damage to the product.
CAUTION:
This can cause damage to the product.
Do not use gasoline with an
Do not use gasoline with
Do not use leaded gasoline.
9