Heat Program - THERMEx STERIMEX LARGE Manual De Instrucciones

48 THERMEX StERIMEx LARGE

HEAT PROGRAM

Always wait 10 min. from the end of
the program before the door is opened.
this allows Sterimex to purify the air of
various fumes and gases, as well as to
cool the cabin.
Heat is used to turn on the Heat purification program. the cleaning program cleans by heating
the cabin.
Press Heat to select the heat cleaning program. the first press of Heat selects the program
and the indicator starts flashing. It is now possible to set how many degrees the program is to
be executed on by pressing Heat repeatedly. Next, the timer can be set by pressing time until
the desired program length is shown in the display. When heat and time are set as desired,
wait approx. 4 sec. without pressing the display and the cleaning program starts. the flashing
display becomes constant and confirms that the cleaning program has started.
IMPORtANt! Do not open the door until 10 min. after completing the program.
During the cleaning process with the Heat program, there is high heat in the cabin, and there
may therefore be a risk of damage by opening the door before the end of the program. Never
open the door while a program is running. Always wait at least 10 min. from the end of the pro-
gram until the door is opened. this also applies even if the program is interrupted on Power.
...
10 min.
M 710212200212052021