Addressing Via Dmx/Rdm - Oase Varionaut 270 DMX/02 Instrucciones De Uso

- EN -

Addressing via DMX/RDM

RDM (Remote Device Management) is an open and bi-directional protocol standard for DMX-controlled devices. The
permanently transmitted DMX data flow briefly pauses (several milliseconds), and an RDM data package (message) is
sent directly to a subscriber. The subscriber evaluates the information in the data package and sends an answer (semi-
duplex) on the same line. Targeted polling to a subscriber via its UID (Unique ID) prevents several subscribers from
answering simultaneously.
The protocol makes it possible to receive status information about a unit or to change configurations on a unit. Chang-
ing the configuration means, e.g. changing the DMX address. The prerequisite for this function is a RDM-compatible
controller. Read the corresponding operating instructions
RDM parameters
General parameters
COMMS_STATUS
STATUS_MESSAGES
STATUS_ID_DESCRIPTION
SUPPORTED_PARAMETERS
PARAMETER_DESCRIPTION
DEVICE_INFO
PRODUCT_DETAIL_ID_LIST
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
SOFTWARE_VERSION_LABEL
DMX_START_ADDRESS
SENSOR_DEFINITION
SENSOR_VALUE
DEVICE_HOURS
DEVICE_POWER_CYCLES
IDENTIFY_DEVICE
RESET_DEVICE
Specific parameters
KENNLINIENPUNKT_X1
KENNLINIENPUNKT_Y1
KENNLINIENPUNKT_X2
KENNLINIENPUNKT_Y2
KENNLINIENPUNKT_X3
KENNLINIENPUNKT_Y3
RUNTIME_HOURS
STARTUP_COUNTER
CONFIG_MODE
STS_OVERTEMP
STS_OVERVOLTAGE_PHASE
STS_UNDERVOLTAGE_PHASE
STS_OVERCURRENT
STS_BLOCKIERT
22
GET SET Description
CMD CMD
Shows general status information of the bus interface
•
Used to manage status messages
•
Used to manage status messages
•
Overview of all RDM parameters
•
Description of all parameters
•
Brief overview of the most important features
•
Additional feature
•
Type designation
•
Manufacturer's designation
•
Labelling field
• •
Firmware version number
•
Reading and setting the DMX start address
• •
Sensor information
•
Sensor value
•
Sensor 1
Sensor 2
Sensor 3
Sensor 4
Sensor 5
Sensor 6
Sensor 7
Sensor 8
Sensor 9
Sensor 10
Operating hour counter
•
Switch-on counter
•
0 = normal mode
• •
1 = pump will switch on and off again at short intervals. This function is helpful for
identifying the device in the field.
Executes a reset.
•
1 = warm start
255 = cold start
GET SET Description
CMD CMD
• •
Support value 1 of the stored pump characteristic curve
• •
• •
Support value 2 of the stored pump characteristic curve
• •
• •
Support value 3 of the stored pump characteristic curve
• •
Operating hour counter for the running period
•
Startup counter
•
Only for service purposes
• •
Status message, overtemperature
•
Status message, overvoltage
•
Status message, undervoltage
•
Status message, operating voltage too high
•
Status message, motor blocked
•
TempLpErrorCount Temperature error counter, PCB
TempWindErrorCount Temperature error counter, motor
MotorFailureCount Motor failure counter
ActualSpeed Current actual speed
NominalSpeed Current set point speed
PWM Current PWM value
Temp Operating temperature, electronic board
Winding Temp Operating temperature, motor
Power Voltage Current intermediate circuit voltage
Current Consumption Current intermediate circuit current