Truper ROU-MN Manual página 12

Operation
Circle cutting guide
• The parallel guide can be configured to cut circles of different
size ranges.
• The radius of the circle is the distance from the anchor (A) of
the guide to the center of the drill bit.
• To cut circles from 2-1/2" to 4-3/4" radius, place the wing nut
in the hole closest to the router (B).
• To cut circles from 4-3/4" to 8-11/16" radius, place the wing
nut in the hole farthest from the router (C).
Circle cutting
NOTE • This guide cannot cut circles with radii from 6-3/4"
guide
to 7-5/16".
F
12
ENGLISH