Publicidad
Idiomas disponibles
Idiomas disponibles
1. Insert the battery (4) on the groove and slip it all the way
until you hear a "click" noise from the lock/unlock
button. At this point, the battery is locked in place;
2. To remove the battery, press the lock/unlock button and
pull out the battery.
Use VITO's 20V lithium-ion batteries.
1. Fit the battery in the charger in the same way as you
would place it in the appliance;
2. Plug the charger into the socket and let it charge.
Sometimes at the end of charging, both the battery and the
charger can be hot, which doesn't mean they are
malfunctioning.
Let the battery cool down before fitting it into the ash
vacuum cleaner.
1. Attach the hose (8) to the suction port;
▪ To vacuum, connect the hose ton the suction port (1);
2. Rotate the hose clockwise to secure it;
3. Check that the hose is properly fixed;
4. Insert the metal telescopic tube (7) into the connector.
To detach the hose:
1. Rotate the hose anticlockwise and disconnect.
Never operate the vacuum cleaner without having
the HEPA filter installed. The HEPA filter prevents ash
and dust intake to the engine, thus preventing breakdowns.
1. Undo the fastening latches (5) and remove the vacuum
cleaner head;
2. Fit the HEPA filter on the motor base;
3. Place the head back on and fasten the latches.
The vacuum cleaner was designed for household use to
vacuum up ash and dry debris, not for use in industrial
environments.
Never use the appliance for vacuuming:
▪ Water or any other liquid;
▪ Dusts hazardous to health (dust class L, M, H);
▪ Hot or flammable objects with temperatures above 40°C.
At temperatures over 40°C there is a danger of
combustion;
▪ Dust or combustible/explosive liquids;
▪ Soot.
Before vacuuming dthe ash, you should take a few
precautions:
▪ Shake the ash with a metal object to check that the ash
is still hot. Ash or debris that seem to have cooled down
may still be extremely hot inside. Ensure that the ash is
completely extinguished before vacuuming;
▪ During ash vacuuming, permanently check the suction
hose and the vacuum cleaner for heating. In case of
overheating, switch off the appliance immediately and
remove the battery.
Avoid vacuuming debris and materials that could decrease
airflow and block or clog suction accessories.
Never use the vacuum cleaner if the suction power is too
low. If this happens, check that the tank is full and check
the cleaning condition of the HEPA filter (refer to the
maintenance instructions). Also check if there are any
blockages or clogging in the hose, tube or suction
accessories.
Make sure the tank (6) is completely empty before you
switch on the appliance.
1. Set the "ON/OFF" switch (3) to position (I);
To switch off the vacuum cleaner:
2. Set the "ON/OFF" switch to position (0).
Publicidad
