Important - Scott Living HDSLFP65W-4A Instrucciones De Montaje

Assembly (continued)
15
Attaching upright arms
IMPORTANT NOTE:
□
See figure A: Fasten upper 2 screws (AA) through the upright arm (C) into the heater (A) until tight.
□
See figure B: Fasten lower 2 screws (AA) into the upright arm (C) until tight.
□
Fully tighten all 4 screws (AA) one final time.
□
Repeat the same process with upright arm (B).
WARNING: Do not lift or transport the heater by using the upright arms.
Figure A
C
AA
16
Attaching logs to ember bed
IMPORTANT: Carefully follow the 2 steps below for inserting each log.
1. Install left log (F) into left hole of ember bed (E) by inserting front edge of base of the log into front notches of
ember bed hole.
2. Then tilt the log back to insert the rear edge of the log base into rear notches of ember bed hole (press down log
firmly to lock into position).
□
Repeat the above process for the right log (G).
Use hand screwdriver, not power driver to assemble fireplace insert
A
C
AA
E
1
A
E
2
. See BILT for video instructions.
Figure B
B
C
AA
G
E
A