Removing And Replacing The Seat Covers - Cybex Silver SOLUTION B-FIX Manual Del Propietário

REMOVING AND REPLACING THE SEAT COVERS

WARNING!
• NEVER USE this booster seat without properly installed fabric covers.
• Do not damage, remove, or dispose of the foam Headrest Pads or Side Pads on this
booster.
REMOVING THE SEAT COVERS
The seat is covered with three separate parts - the
Headrest Cover A, Backrest Cover B, and Seat
Pad C. To remove these parts, please follow the
instructions below.
Headrest Cover q: From the front of the seat,
remove the two elastics from the hooks at the top
of the shoulder belt guides
Cover forward to remove.
Note: For Solution B2-Fix+Lux, you will also need
to unfasten the hook-and-loop connectors B at the
rear of the Three Position Reclining Headrest.
Backrest Cover w: Undo the four snaps on the rear
of the seat and pull the Backrest Cover off the seat
back.
Seat Pad e: Remove cup holder(s) if installed,
undo the two snaps at the rear of the seat base, and
remove the Seat Pad.
DEATH or SERIOUS INJURY can occur
and pull the Headrest
A
A
B
C
w
q
B
A
e
28