Adjusting The Headrest; Reclining Headrest - Cybex Silver PALLAS-FIX Manual Del Usuario

ADJUSTING THE HEADREST

EN
The headrest (c) can be adjusted by using the headrest height adjuster (d)
at the back of the headrest (c). Adjust the headrest so that max. 2 cm (approx.
2 finger's width) remain between the child's shoulder and the headrest (c).
The height of the headrest can still be adjusted while the car seat is
��
installed in the vehicle.

RECLINING HEADREST

The reclining headrest (c) helps to prevent the child's head from dangerously
tipping forward during sleep. It can be set to one of 2 positions. Push the
reclining headrest (c) forward until the desired position is reached. To return
it to the original position, pull the reclining headrest (c) upwards and push it
back again.
The child's head should always be in contact with the reclining headrest.
��
CORRECT INSTALLATION MODE
Group 1: 9 ‒ 18 kg
Installation
with base and
impact shield
mode
Installation
9 - 18 M
with booster inlay
8
Group 2/3: 15 ‒ 36 kg
without base and
impact shield
> 19 M
without booster inlay
SECURING THE CHILD WITH IMPACT SHIELD – GROUP 1 (9–18 KG)
1. Insert the impact shield (f). The side flaps of the impact shield (f) fit exactly
between the arm rests and seating surface of the booster. Push the
adjustment buttons (q), so that the impact shield (f) will slide into the widest
position. By releasing the buttons (q) the impact shield (f) will be locked in
position. Adapt the impact shield (f) to your child.
2. Pull out the entire length of the vehicle seat belt.
3. Place the lap belt over the designated red belt routing on the impact shield (g).
4. Lock the vehicle seat belt into the belt buckle. It must lock in place with an
audible "CLICK".
5. Tighten the lap belt by pulling the shoulder belt backwards.
6. Feed the shoulder belt in parallel with the lap belt back into the belt routing
(g) and pull the shoulder belt tight. Ensure that both parts of the belt cover
the entire width of the impact shield (f) in the belt routing (g).
7. Feed the shoulder belt tightly through the belt routing of the impact shield (g)
until it is clamped inside the belt guide.
8. Put the shoulder belt between headrest (c) and backrest (b). The shoulder
belt does not need to be guided through the shoulder belt guide (i).
ADJUSTING THE LYING POSITION (9-18 KG)
1. To put the seat in the lying position, press the position adjustment button (r).
2. To return the seat from the lying position to the sitting position, press the
position adjustment button (r) again and guide the seat upwards with light
pressure against the booster (e).
The lying position is only available for group 1 (9-18 kg).
��
SWITCH FROM GROUP 1 TO GROUP 2/3
1. Remove the impact shield (f), as soon as your child weighs 18 kg.
Switching from group 1 to group 2/3 is not permitted if your child weighs
��
less than 15 kg. Keep the impact shield in a safe and secure place.
2. Press the two release buttons of the base (t) on the underside of the booster
(e) and pull it away from the base (s) until there is some resistance.
3. Press the position adjustment button (r) and pull the seat away from the
base (s) completely.
4. To remove the spacers (p), pull up the backrest cover to reveal the finger
hole on the backside of the backrest.