Center High-Mount Stop Light (Chmsl) Qty; Screw Qty; Qty. 1; Flat Washer Qty - Bestop 77336 Instrucciones De Instalación

Install Center High-Mount Stop Light
Section 13
Using a utility knife, cut a 1" wide slit
through both layers of fabric in the area
above the middle of the rear window, and
in the vertical center of the fabric.
P17 - 77336 Rev. F 0922
Hardware Kit #576.71
Utility Knife
Center High-Mount Stop Light
- CHMSL -
#10-32 Screw
Qty. 2
Flat Washer
Qty. 2
#10-32 Nut
Qty. 2
Installation Instructions - Supertop for Trucks
Screwdriver
5/16" Wrench

Qty. 1

Phillips
and
Feed the connector end of the CHMSL wire
harness through the slit in the top fabric,
and pull the wire all the way through both
layers of fabric.
Make sure that the light is centered,
straight and level, and attach the Stop Light
to the top fabric using two (2) 10-32 Screws,
two (2) Flat Washers and two (2)
10-32 Nuts. The Nuts and Flat Washers go
on the inside of the fabric.
You'll need to pierce the fabric for the
screws to go through.
Page 17
© 2020 Bestop, Inc.