Installation Information - BOMANN CL 6044 QC CB Manual De Instrucciones

Idiomas disponibles

• Before connecting the pipes, decide where you want to place the

exterior unit and take care to ensure that there is enough room in the

location you have chosen for maintenance work to be performed at a

later time. (Observe the minimum distances)

• Put the protective caps (included in delivery) on the stand and fasten

these in the appropriate places.

• Use exceptionally sturdy screws / bolt anchors and bear in mind also

the weight of the appliance, in order to prevent vibrations caused by

operation from loosening the connection over time. The unit must be

installed in accordance with the applicable safety regulations.

Condensed Water Drain Pipe for the Exterior Unit

Condensed water and ice which build up in the exterior unit due to heat

generation can be drained by means of the condensed water pipe.

1. Fasten the supports for the condensed water drain pipe in the 25 mm

opening designed therefor.

2. Connect the supports for the condensed water drain pipe to the con-

densed water pipe and ensure the flow is properly controlled in order

to avoid moisture damage.

Electrical Connection (Exterior Unit)

Remove the connector cover (15) on the right side of the appliance. The

associated diagram can be found on the rear side. See diagram.

1. Connect the power supply cable for the interior unit to the terminal

strip.

2. Carefully attach the power supply cable for the exterior unit using the

cable connecting clamps.

3. Make sure that the cables have been properly attached. Be sure that

the grounding has been correctly installed.

4. Place the protective cover back on the appliance.

CAUTION:

All electrical works must be performed by a certified professional elec-

trician or specialist electronics company. Improper installation shall

result in expiry of the warranty.

Connection, Filling and Start-up Procedure

The coolant pipes are not filled, and this must be done before use.

The filling procedure may only be carried out by a certified specialist

company. For any further installation requirements, please contact the

appropriate specialist company.

Design model / Cooling capacity (Btu / h)

Cooling pipe diameter a)

Cooling pipe diameter b)

Standard cooling pipe length

Maximum distance between interior and exterior unit

Additional refrigerant charge

Maximum distance between interior and exterior unit

Cooling agent *

*) Additional information can be found on the information plate on the exterior unit.

CL6044CB_IM

Installation of the Exterior Unit

• The air conditioning unit must be installed and connected by a certi-

fied refrigeration and air conditioning company. Improper installation

shall result in expiry of the warranty.

• Operating the appliance without filling with coolant can cause

damage!

• Is the power switch functioning properly?

• Does the ventilator work?

• Do the operating modes function normally?

• Can temperature and time be accurately adjusted?

• Do all lamps light up in normal fashion?

• Are the airflow flaps functioning properly?

• Is the condensed water pipe functioning normally?

All of the steps described above must be performed by a certified

refrigeration and air conditioning company. Improper implementation

shall result in expiry of the warranty.

• Can unusual noises or vibrations be detected during operation?

• Is the cooling agent leaking?

NOTE:

The electronic control system will only start the compressor three

minutes after the unit is switched on.

All of the steps described above must be performed by a certified

refrigeration and air conditioning company. Improper implementation

shall result in expiry of the warranty.