Fcc Statement - Furrion VISION S FOS07TASR Manual De Usuario

Important Safety Instructions
Installation
● Installation and wiring of this product
require specialist skills. To ensure proper
and safe installation, please seek a
specialist technician.
● Only use supplied or recommended parts.
● Use watertight connectors for the camera
power supply cable to power source.
● Connect the camera to a 12-24V DC
circuit using 18AWG or larger cables.
● Ensure correct polarity of DC power
supply to the camera.
● To reduce the risk of fire, connect the
camera only to a circuit provided with
a maximum branch-circuit over current
protection device.
● Do not route wiring in areas that may get
hot.
● Take necessary precautions when working
at elevated levels.
Use
● Electrical appliances and overhead power
lines can affect the wireless signal.
● Do not place the monitor in a location
where it might hinder field of vision while
driving.
● Consideration should be given to any
airbags when installing the monitor. Do
not place the monitor where it might
hinder the airbag or become hazardous if
the airbag is deployed.
Care
● Do not wash the vehicle with an automatic
car wash or high pressure water. This may
damage the camera.
● Clean the LCD screen with a microfiber
cloth. Do not use coarse or abrasive
materials.
● Do not use alcohol or ammonia based
products to clean the LCD screen. Only
use specialist screen cleaning products.
● Use a wet cloth to clean the camera lens.
A dry cloth may scratch the camera lens.
CCD-0005559 Rev: 04-29-22

FCC Statement

The equipment complies with RF exposure
limits. This module is limited to installation
in mobile or fixed applications. The antenna
used for this transmitter must not be co-
located or operating in conjunction with any
other antenna or transmitter.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: The Grantee is not responsible for
any changes or modifications not expressly
approved by the party responsible for
compliance. Such modifications could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
- 5 -