Tool Change - Mafell FM 1650 PV-LO Traducción Del Manual De Instrucciones Original

Permissible cutter diameter:
Material
Rigid foam
PE1000
PA6GF30
Wood (soft)
Wood (hard)
MDF
Chipboard
Aluminium
CBN pencil grinder
Normal corundum

4.3 Tool change

4.3.1 Tool clamping by means of collet
The spindle 1 (Fig. 1) of the milling and grinding motor is equipped with a precision collet 2 (Fig. 1) to hold the
tools. The spindle lock is triggered by the locking button 4 and facilitates tightening and loosening of the union
nut 3 (Fig. 1).
Proceed as follows for the tool change:
- Lock the spindle 1 (Fig. 1) to unclamp the tool by pressing the locking button 4 (Fig. 1).
- Detach union nut 3 with an open-ended spanner AF 22.
- Pull off the tool to the front.
- Push the new tool into the tool holding fixture up to the limit stop.
- Check the tool's seat.
- Spindle 1 (Fig. 1) is locked when the tool is clamped.
- Tighten union nut 3 with the open-ended spanner SW 22.
Alternative spindle lock method:
- Use the second open-ended spanner SW 22 on the key face of the spindle.
20
Only straight shanks with tolerance range H7 or HA shanks according to
DIN EN ISO 6535 are permitted, as high speeds may otherwise result in a major
imbalance.
Danger
Pull the power plug during all service work.
Wear protective gloves during a tool change. The insertion tool can get very hot
during longer operation and/or the insertion tool's cutting edges are sharp.
30 40
-29-
45 50 60