Adjusting The Rear Stop; Walking Resistance Brake; Backstop; Direction Lock - Vela Meywalk 4 Manual De Instrucciones

E N

2.0.13. ADJUSTING THE REAR STOP

Lower the rear stop to find an Allen screw inside the square
profile. Loosen the screw and set the longitudinal direction to the
desired position. remember to retighten the Allen screw.

2.0.14. WALKING RESISTANCE BRAKE

By activating the walking resistance brake the walking resistance
increases. This can both reduce speed (both sides) and correct
for skewed gait (one side). Loosen the nut at the bottom of
the screw and adjust the screw until the desired resistance is
achieved. Tighten the nut again. Note: The walking resistance
brake is set individually on both sides.

2.0.15. BACKSTOP

By activating the backstop on both rear wheels, the gait trainer
can only be walked forward. Activate by lifting up the silver
button and deactivate by pressing the black return button.
Note: Always activate/deactivate the backstop on both sides.

2.0.16. DIRECTION LOCK

By activating the direction lock, the gait trainer can only move
in a straight line. Turn the snap lock while the wheel is straight
on the frame so the locking pawl hits the hole in the wheel
fork. Pull the snap lock backwards and turn it to locked position
to deactivate - so that the wheel can rotate freely.
Note: Always activate/deactivate the lock on both sides.
1 5