DASH DISASSEMBLY 1. Unclip, unplug and remove the dash panel surrounding the radio. (Figure A) 2. Remove (4) 9/32” screws securing the radio/climate control panel, then unplug and remove. (Figure B) 3. Remove (2) 9/32” screws securing the radio chassis, then unplug and remove. (Figure C) Continue to Kit Assembly (Figure A) (Figure B) (Figure C) 386.257.1187 MetraOnline.com...
KIT ASSEMBLY 1. Attach the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. Locate the factory wiring harness and connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess. Test the radio for proper operation. 3. Slide the radio/bracket assembly into (Figure A) the radio cavity in the sub dash. (Figure B) 4. Attach the radio housing using the factory screws. (Figure C) 5. Reassemble the dash in reverse order (Figure C) of disassembly. (Figure B) REV. 7/14/2021 INST95-3025B...
DESMONTAJE DEL TABLERO 1. Desenganche, desconecte y quite el panel del tablero que rodea el radio. (Figura A) 2. Quite los (4) tornillos de 9/32” que fijan el panel del radio/control del clima; posteriormente, desconecte y retire. (Figura B) 3. Quite los (2) tornillos de 9/32” que fijan el chasis del radio y posteriormente, desconecte y retírelo.
(Figura A) 2. Localice el arnés de cableado de fábrica y el conector en el tablero y realice todas las conexiones necesarias al radio. Metra recomienda el uso de adaptadores de acoplamiento adecuados de Metra o de Axxess. Pruebe el radio para asegurarse de que funciona bien.