Publicidad
Idiomas disponibles
Idiomas disponibles
• An extension cord must have adequate wire size for safety.
An undersized cord will cause a drop in line voltage resulting in loss
of power and overheating. When using more than one extension
to make up the total length, be sure each individual extension
contains at least the minimum wire size. The following table shows
the correct size to use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
Voltage (Volts)
Total length of cord in meters (m)
120–127V
0–7
220–240V
0–15
Rated Ampere
Minimal cross-sectional area of the
range
0–6A
1.0
6–10A
1.0
10–12A
1.5
12–16A
2.5
• Do not place any object on top of the charger or place the
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger
in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
• Do not operate the charger with a damaged cord or plug.
• Do not operate the charger if it has received a sharp blow,
been dropped or otherwise damaged in any way. Take it to
an authorized service center.
• Do not disassemble the charger; take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock, electrocution or fire.
7–15
15–30
30–50
15–30
30–60
60–100
cord in meters (mm
)
2
1.5
1.5
2.5
1.5
2.5
4.0
1.5
2.5
4.0
4.0
Not Recommended
• Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 120V or
220V household electrical power. Do not attempt to use
it on any other voltage. This does not apply to the vehicular
charger.
CAUTION: When not in use, place tool on its side on a stable
surface where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery
pack but may be easily knocked over.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
(grounded)
................. Class II Construction
(double insulated)
.../min .......... revolutions per minute .......................speed
BPM ............. beats per minute
IPM ............... impacts per minute
SPM ............. strokes per minute
sfpm ............. surface feet
.....................
per minute
.....................
16
A ......................amperes
W .....................watts
or AC ..........alternating
current
or AC/DC ...alternating
........................or direct
current
n o ....................no load
n ......................rated
........................speed
.....................earthing
terminal
.....................safety alert
symbol
Publicidad
