STERWINS UP40 Instrucciones De Montaje, Utilización Y Mantenimiento página 205

8.3 TROUBLESHOOTING
FR
ES
PT
Problems
IT
EL
Product does
PL
not blow
RU
KZ
UA
RO
EN
Product does
not start
Product does
not reach full
power
Result is
unsatisfactory
Vibration
or noise is
excessive
DANGER ! Risk of injury due to electric shock.
Warning ! Before any trouble shooting, switch off the product.
Probable causes
Blocked tube
Blocked impeller
Battery is not secure
Battery is not charged
Battery is not secure
Battery is not charged
Power/speed switch is in the
OFF position
Tubes are not correctly
installed
Battery pack not properly
attached
On/off switch not set on ON
position
Battery pack capacity too
low
Air vents are blocked
Nozzle not properly
assembled
Nozzle not properly
assembled
Bolts/nuts are loose
Solutions
Clear the blockage
To secure the battery pack,
make sure the latches on the
top of the battery pack snap
into place
Charge the battery pack
according to the instructions
included with your model
To secure the battery pack,
make sure the latches on the
top of the battery pack snap
into place
Charge the battery pack
according to the instructions
included with your model
Press the on/off switch
Check tubes to ensure that
they are allowing the switch
to be engaged when correctly
installed
Attach properly
Refer to chapter "Start the
product"
Charge battery pack
Clean the air vents
Refer to chapter "Attaching/
Removing the tube "
Refer to chapter "Attaching/
Removing the tube "
Tighten bolts/nuts
204
Qualification
required
No specific
qualification is
required
No specific
qualification is
required
No specific
qualification is
required
No specific
qualification is
required
No specific
qualification is
required