Setup And Operation - Klarstein EMERALD 5 SLIM Manual De Instrucciones

SETUP AND OPERATION

Starting the washing process
1. Pull out the lower and upper baskets, fill the baskets with dishes and push
them back into the appliance.
2. Add the dishwashing liquid.
3. Plug the power plug into the wall socket. Make sure that the water tap is
turned on completely.
4. Close the door and press the On/Off button to switch on the appliance.
5. Select a programme. The corresponding indicator lamp lights up. As soon
as you press the Start/Pause button, the dishwasher starts the selected
programme.
Changing the programme after starting
A programme can only be changed if the appliance has only been running for
a short time. Otherwise, the dishwasher detergent may already be in the wash
water. If this is the case, the dishwasher must be reset and refilled with new
detergent. To reset the dishwasher, proceed as follows:
1. To pause the washing process, press the Start/Pause button.
2. Press the button of the set programme for 3 seconds. The programme is
cancelled.
3. Set the desired programme.
4. Press the Start/Pause button. The dishwasher is restarted.
Adding dishes later while a programme is running
You can still add dishes even if a programme has already started. However, if
the appliance is no longer in the washing cycle, subsequently added dishes may
not clean properly or may soil other dishes. Make sure that the appliance is not
already in the rinsing cycle.
Follow the steps below:
1. To pause the washing process, press the Start/Pause button.
2. Wait 5 seconds before opening the door.
3. Put the extra dishes inside.
4. Close the door.
5. Press the Start/Pause button. The dishwasher is restarted.
EN
61