Troubleshooting - Klarstein EMERALD 5 SLIM Manual De Instrucciones

EN
66

TROUBLESHOOTING

Note: Before contacting customer service, check if your problem is listed in the
table below and follow the mentioned solution.
Problem
The dishwasher does
not start.
No water is pumped out
of the dishwasher.
Foam in the tub.
Potential cause
The fuse is out or blown.
No power.
The door is not closed
properly.
The drain hose is kinked.
The filter is clogged.
The drain is blocked.
Incorrect dishwashing
detergent.
Solution
Replace the fuse or
flip the switch again.
Remove all other devices
that are connected to
the circuit themselves.
Make sure that the
appliance is switched on,
the door is firmly closed
and the mains cable is
firmly plugged into the
socket.
When closing, make
sure that the door lock
engages.
Check the drain hose.
Clean and check the
filter.
Check your drain and
clean it if necessary. If
you still have problems.
Contact a specialist
company.
Only use detergent
that is suitable for
dishwashers. If there
is still foam in the
tub, open the door
and allow the foam to
evaporate. Fill the hose
with approx. 4.5 litres of
water. Close and lock the
dishwasher and start any
programme to drain the
water. Repeat this step if
necessary.